Tungsten carbide, also called cemented carbide, is a composite. Hard tungsten carbide (WC) grains are held together by a softer metal binder, most often cobalt. Two variables explain much of the difference between grades: how much cobalt there is, and how large the WC grains are.
What cobalt does
Cobalt is the tough phase in the material. As its share increases, the material generally becomes tougher and better able to absorb impact, but it also becomes softer and less resistant to abrasive wear.
The three grades below have the same 1.5 μm grain size, so the change comes mainly from cobalt:
| Grade | Co (%) | Grain size (μm) | Hardness (HRA) | Density (g/cm³) |
|---|---|---|---|---|
| YG8 | 8 | 1.5 | 90 | 14.7 |
| YG15 | 15 | 1.5 | 87 | 14.05 |
| YG20 | 20 | 1.5 | 85 | 13.6 |
Hardness falls steadily as cobalt rises. Density falls too, because cobalt is much lighter than tungsten carbide.
What grain size does
At the same cobalt content, finer WC grains generally produce a harder material with better wear resistance and the ability to hold a sharper edge. Compare two grades that both contain 12% cobalt:
| Grade | Co (%) | Grain size | Hardness (HRA) | TRS (N/mm²) |
|---|---|---|---|---|
| MS12UF | 12 | 0.4 μm | 92.5 | 4000 |
| MCG5 | 12 | Medium | 88.3 | 3300 |
With the same cobalt share, the ultrafine grade is more than 4 HRA harder. This is why fine and ultrafine grades are widely used for cutting tools and other parts that need sharp, stable edges.
Why strength does not follow a simple rule
Transverse rupture strength (TRS) is often used to compare grades, but it does not rise or fall in a straight line with cobalt or grain size. It also depends on the microstructure, on defects such as porosity, and on the manufacturing process. Treat TRS as one data point, and do not choose a grade on that number alone.
Putting the two together
Cobalt and grain size can be balanced against each other, which is why very different grades can suit very different jobs:
- Low cobalt, fine grain: high hardness and wear resistance, for precision finishing and fine edges.
- Moderate cobalt, fine grain: a balance of edge strength and hardness, often used for solid carbide tools.
- High cobalt, coarser grain: high toughness for impact and forming, such as stamping and heading dies.
What to check on a data sheet
Cobalt content and grain size explain the direction of a grade, but they do not predict performance on their own. Read them together with hardness, density and TRS, and always check how the values are stated, since many published figures are typical values.
You can compare typical properties on the Grades page, or ask our engineers which grade suits your operating conditions.

